Command -  

   


This command will draw a mix of weld connections such as rat tail copes, elbows, and CNC-lasered tube connections : 



This command can also draw many connections were created specifically for rectangular tubes and pipes that will be produced with a CNC laser.
Some of them will have inserts in the tubes so that they will fit instantly. They are perfect for assembling and welding in the shop without the need to measure and no mistakes can be made!

These are the connections in this command that need some more explanation  :

Pipes connected hollow

This connection cuts open the vertical pipe, and the horizontal pipe fits in perfectly.

The connection will also work in inclined situations.

Pipe to Pipe with inserts

This connection does not completely open the vertical pipe but only adds an optional vent hole to it.
Inserts are added to the horizontal pipe so that it can fit in the same-sized holes in the vertical pipe.

The connection will also work in inclined situations.

T connection with inserts

This connection adds inserts to the horizontal tube so that it can fit in the same-sized holes in the vertical tube.

The connection will also work in inclined situations.

Miter with inserts

This connection draws a miter to connect the tubes, but it also adds inserts to the tube that was selected first so that it can fit in the same-sized holes in the other tube.

Pipe miter with inserts

This connection draws a miter to connect the pipes, but it also adds inserts to the tube that was selected first so that it can fit in the same-sized holes in the other pipe.

The angle at which the pipes arrive does not matter.

Half on Half

This connection is for 2 rectangular tubes that intersect each other. They will both be cut open halfway to make them fit perfectly on each other.

The tube that you select first will get it's top half cut away, the secondly selected tube will get it's bottom half cut away.

The connection will also work in inclined situations.